ENSONIQ ASR-10 Bedienerhandbuch PDF herunterladen (Seite 40)

Section 1 — Controls and Architecture

About the Sequencer 29

Saving a Song (along with all Sequences) to Disk

Once you have created a song or made changes to an existing one, you can save the song to a

formatted ASR-10 disk. In addition to saving the song itself, the SAVE SONG + ALL SEQS

command saves all the individual sequences currently in memory (whether they are part of the

song or not). To save a song:

• Insert a formatted disk into the drive.

• Press Command, then press Seq•Song.

• Press the Left or Right Arrow button until the display reads SAVE SONG + ALL SEQS.

• Press Enter•Yes.

• Edit the song name (if needed):

SEQ

STOP

CMD

The display shows the current name of the song, with a cursor (underline) beneath the first

character. If you want to give the song a new name, do so at this time. Use the Data Entry Slider

or the Up/Down Arrow buttons to change the underlined character, then press the Left/Right

Arrow buttons to move the underline. Repeat until the display shows the name you want (if you

don’t need to rename the song, just skip this step).

• Press Enter•Yes. The display will read SAVING <SONG NAME> while the song is being

saved.

• If there is already a song file with the same name on the disk, the display will ask DELETE

OLD VERSION? Press Enter•Yes to save the song, replacing the one on the disk. This is for

updating songs to which you have made changes. Or press Cancel•No to abort the

procedure.

• If there is not enough free space on the disk, the display will say NOT ENOUGH DISK

SPACE. Save the song to another disk (or delete some files from the disk).

• Note that the song and all sequences in memory are saved as one file. You cannot extract a

single sequence from a song file and load it separately. If you want access to a sequence

individually, you must first load the song into the internal memory, and then save the

individual sequence using the SAVE CURRENT SEQUENCE command.

Deleting a File from Disk

Deleting of disk files is done from Load mode. To delete (erase) a file from a disk:

• Press Load, followed by the page button (Instrument, Seq•Song, System•MIDI, or Effects)

for the type of file you want to delete.

• Press the Up or Down Arrow button until the file you want to delete is showing on the

display.

• While holding down the Load button, press Cancel•No. The display will ask DELETE <FILE

NAME>?

• Press Enter•Yes. Press Cancel•No to abort this procedure.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 389 390

Keine Kommentare

ENSONIQ ASR-10 Bedienerhandbuch Seite 40