ENSONIQ ASR-10 Bedienerhandbuch PDF herunterladen (Seite 186)

Section 10 — Wave Data Parameters ASR-10 Musician’s Manual

6 Command/Wave Page

• Select WAVESAMPLE INFORMATION. Press Enter•Yes.

• The display reads WS NAME=#####. Use the data entry controls to name the WaveSample

as you would any other file. Press Enter•Yes.

• The display reads SAMPLE RATE=##KHZ. You can now use the Up/Down Arrow buttons to

change the sample rate at which the sample will play. Notice that changing the sample rate

effectively changes the playback pitch as well. Press Enter•Yes.

• The display reads ROOT KEY=##. The Up/Down Arrow buttons will now change the root

key. Press Enter•Yes.

• If the WaveSample is a copy, the display will read COPY OF LYR ## WS ##. This parameter

is display only, and cannot be changed.

If you get the message, LAYER NOT IN PATCH, press Edit, then Instrument. Use the Arrow

buttons to enable the layer in the current patch.

CMD

TRUNCATE WAVESAMPLE

WAVE

Press Command / Wave / 4

Truncating removes data before the sample start, and/or after the sample end at the same time.

The memory formerly used by the truncated data is then returned to the available memory.

Before:

After:

SAMPLE

START

SAMPLE

END

SAMPLE

START

SAMPLE

END

• Select TRUNCATE WAVESAMPLE. Press Enter•Yes.

Note: When STEREO LAYER LINK= ON, this command will be simultaneously performed on the

corresponding WaveSample in the companion layer.

About Loop Commands

In the following loop commands, the messages INCREMENT LOOPSTART, or DECREMENT

LOOPEND may appear. When they do, the ASR-10 is letting you know there’s a problem with

the loop length. Try changing the FADE ZONE. You could also press Edit, then Wave, and

adjust the loop points. To move the loop points one sample at a time, make sure AUTO-LOOP

FINDING (on the Edit/System•MIDI page) is OFF.

Note: Whenever the KEEP=OLD NEW message appears, the ASR-10 is giving you the chance to

“audition” the results of the operation, before you commit any changes to memory.

1 2 ... 181 182 183 184 185 186 187 188 189 190 191 ... 389 390

Keine Kommentare

ENSONIQ ASR-10 Bedienerhandbuch Seite 186