ENSONIQ ASR-10 Bedienerhandbuch PDF herunterladen (Seite 305)

Section 13 — Sequencer and Audio Track Parameters

Track Commands 23

CMD

SCALE EVENT

TRACK

Press Command / Track / 7

Use this command to increase or decrease the effect of a controller in a track.

• Press Enter•Yes. The display reads TRACK=##.

• Scroll to SCALE=__. The controllers on this page include:

KEY-VELOCITY CNTL-XX.XCTRL

CNTL-1.MODWHEEL ALL.CONTROLLERS

CNTL-4.PEDAL CHANNEL-PRESSURE

CNTL-7.VOLUME MIXDOWN-VOLUME

CNTL-64.SUSTAIN MIXDOWN-PAN

CNTL-70.PATCHSEL PITCH-BEND

• Scroll to SCALE BY ##. This value is a percent. The Data Entry Slider sets the whole number

values; the Up/Down Arrow buttons set the fractional value. Values of less then 1.00 will

decrease the effect of a controller. Values greater than 1.00 will increase the effect of a

controller.

• Scroll to RANGE. Here you can select the entire range, or define a key range, and bar/beat to

be scaled.

• Press Enter•Yes. The display reads KEEP=OLD/NEW. Press the Play button to audition this

event.

• Press Enter•Yes to complete the command (or Cancel•No to abort the procedure).

CMD

SHIFT TRACK BY CLOCKS

TRACK

Press Command / Track / 8

This command allows you to shift all note events on a track forward or backward in time. This

can be useful for correcting MIDI delay, or creating a “lazy” or “rushed” feel when a track is

shifted relative to other tracks.

• Scroll to SHIFT TRACKS BY CLOCKS.

• Press Enter•Yes. The display reads TRACK=##.

• Scroll to SHIFT AMOUNT=## (Range -96 to +96 clocks).

• Press Enter•Yes. The display reads KEEP=OLD/NEW.

• Press Enter•Yes to complete the command (or Cancel•No to abort the procedure).

1 2 ... 300 301 302 303 304 305 306 307 308 309 310 ... 389 390

Keine Kommentare

ENSONIQ ASR-10 Bedienerhandbuch Seite 305