ENSONIQ ASR-10 Bedienerhandbuch PDF herunterladen (Seite 378)

Appendix ASR-10 Musician’s Manual

XII Additional 44 kHz Effect Descriptions

DRY 44EQ+DDL Range: 0 to 99

44DDL+CHORUS, 44DLYLFO+REV,

44ROTO+REVRB, 44EQ+ROT+DDL

Range: -99 to +99

This parameter allows you to define how much of the signal you want to completely bypass the

effect. Setting this parameter to 0 will eliminate the dry signal. By setting this parameter to 99

and the WET parameter to 0, you can assign voices to be completely dry. Negative values will

reverse the polarity, offering a tonal variation. Note that for 44ROTO+REVRB and

44EQ+ROT+DDL, you can simulate the typical “leakage” of a rotary speaker by setting the DRY

parameter to approximately half of the SPKR WET value. This offers the best rotating effect at a

slow speed.

ECHOTIME L and R 44DDL+CHORUS Ranges: 0 to 1000 msec

44EQ+ROT+DDL Ranges: 0 to 700 msec

Sets the amount of delay time for the independent delays. Each value increases the delay time by

1 millisecond. Experiment with different settings to find the right mix for your sound source and

application.

ECHO LEV Range: 0 to 99

Adjusts the volume of the delayed signals against the original dry signal. A level of 0 will offer

no audible delay.

ECHO REGEN (L and R) Ranges: -99 to +99

Determines the amount of signal that will be fed from the output of the delay back into the input,

increasing the number of repeats in the delay. A setting of 99 would offer an infinite delay. The

sign of the value determines the polarity of the regen (regeneration).

ECHO SEND Range: 00 to 99

Controls the amount of delay being sent into the chorus. A setting of 0 would offer no delay.

ECHOTIME (L and R) 44EQ+DDL Ranges: 0 to 700 msec

44DDL+CH+REV Ranges: 0 to 500 msec

44EQ+DDL+CHO Ranges: 0 to 1400 msec

These parameters control the delay times for the left and right echoes. Each value increases the

delay time by 1 millisecond. Experiment with different settings to find the right mix for your

sound source and application.

ECHO WET Range: 0 to 99

This parameter controls the volume of the echoed signal only. Setting this parameter to 0 will

eliminate the echo portion completely.

EQ BW Range: 0 to 20K

This parameter is a bandwidth control that determines the width of the resonant peak at the mid-

frequency band. By lowering the value, you can produce a narrower bandwidth.

EQ FREQ Range: 0 to 20000

Sets the center of the mid-frequency parametric.

EQ IN Range: -99 to +48 dB

Allows you to adjust the input level trim to the EQs to eliminate the possibility of clipping

boosted signals.

1 2 ... 373 374 375 376 377 378 379 380 381 382 383 ... 389 390

Kommentare zu diesen Handbüchern

Keine Kommentare

ENSONIQ ASR-10 Bedienerhandbuch Seite 378

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Digitale Klaviere ENSONIQ ASR-10