ENSONIQ ASR-10 Bedienerhandbuch PDF herunterladen (Seite 259)

Section 12 — Sequencer and Audio Track Concepts ASR-10 Musician’s Manual

32 About Audio Tracks

Auditioning DiskTracks

When auditioning a DiskTrack recording, you cannot switch between OLD and NEW on the

Audition page while the sequencer is in play. This is because the sequencer must be stopped to

properly prepare DiskTracks. The STOP SEQUENCER FIRST error message will be displayed if

you try. You must first press Stop•Continue, select OLD or NEW, and then press PLAY.

About Syncing Audio Tracks to MIDI Clocks

When recording or playing back Audio Tracks, we highly recommend the Edit/Seq•Song,

CLOCK SOURCE=INTERNAL (i.e. not slaved to an external MIDI clock). This is because the

external MIDI clock may not have a consistent tempo, and the Audio Track playback could drift

out of sync with the sequence tracks. When you configure Audio Tracks for DiskTracks

(ATRK PLAY/REC=SCSI), the ASR-10 automatically sets the sequencer CLOCK SOURCE

parameter to be INTERNAL. Then, as long as you have Audio Tracks configured for SCSI, you

cannot change the CLOCK SOURCE parameter. Whenever the Audio Tracks are reconfigured

for RAM or OFF, the CLOCK SOURCE parameter can be changed.

When Does the System Automatically Reconfigure for RAMTracks?

When the system boots up, it is configured for RAMTrack recording by default. Once it is

configured for SCSI, there are several ways it can be reconfigured back to RAM. One way is to

run the CONFIGURE AUDIO TRACKS command and set it manually. There are times when the

ASR-10 automatically reconfigures for RAMTracks (in order to free up memory that is being used

by the SCSI Buffers). This happens when you enter Sampling, BACKUP/RESTORE, COPY

FLOPPY DISK, COPY SCSI DRIVE, or use the MIDI SYS-EX RECORDER. In all these cases, the

ASR-10 needs the maximum RAM memory that’s available, and that means releasing the SCSI

buffers. Most of these actions (except entering sampling) will prompt you with “MUST ERASE

MEMORY-OK?” before continuing.

1 2 ... 254 255 256 257 258 259 260 261 262 263 264 ... 389 390

Keine Kommentare

ENSONIQ ASR-10 Bedienerhandbuch Seite 259