ENSONIQ ASR-10 Bedienerhandbuch PDF herunterladen (Seite 183)

Section 10 — Wave Data Parameters

Edit/Wave Page 3

Note: The maximum loop length is 1.5 MegaWords.

Tip: There is a quick way to copy any of the SAMPLE START, SAMPLE END, LOOP START, and

LOOP END parameter values from one parameter to another. This can eliminate the hassle of

having to write the value down when, for example, you want the SAMPLE START to be set to the

same value as the LOOP START, or vice versa. To use this function:

• Underline the value to be copied.

• Press the Enter•Yes button.

• Go to the parameter that you want to paste the copied value into (make sure this destination

parameter value is underlined).

• Press the Cancel•No button.

EDIT

LOOPPOS

WAVE

Press Edit / Wave / 5

This parameter displays the LOOP START but moves both LOOP START and LOOP END,

keeping the size of the loop the same. It lets you search for the perfect loop location after you’ve

set up an optimal loop length.

EDIT

MOD / SRC

WAVE

Press Edit / Wave / 6 (Mod Type) 7 (Mod Source)

These parameters allow you to modulate certain parameters of the wave and select the mod

source. The first parameter is WAVE MOD TYPE. This specifies which of the wave parameters

the modulation will be affecting. There are seven possible MOD TYPES:

• OFF — Wave modulation is disabled.

• LOOP POS — Selecting this setting will modulate the loop position of the wave, moving it

forward (towards the end of the wave) with positive values and backward (toward the

beginning of the wave) with negative values.

• START — The SMPL START will be modulated.

• START+LP — Both the SMPL START and the Loop Position will be modulated. When

START+LP is selected, sample playback will always begin at the LOOP START value, rather

than at the SMPL START value.

• LOOPSTRT — Modulates the Loop Start parameter. This will have the effect of either making

the loop shorter (by using positive modulation values to move the Loop Start point closer to

the Loop End) or longer (negative values moving the Loop Start away from the Loop End).

• LOOP END — Works the same as LOOPSTRT, but from the back end.

• LPSTRT–X — This setting works the same as LOOPSTRT, but a pitch correction scheme is now

employed to keep the pitch constant as the loop gets longer and shorter.

• TRANSWAV — Similar to LOOP POS, but the loop will move in increments of exactly one

loop length. For example, with LOOPSTART at 0 and LOOPEND at 100, positive modulation

will cause the loop to jump to LOOPSTART 100, LOOPEND 200, and then LOOPSTART 200,

LOOPEND 300, etc. When this setting is selected, the MOD RANGE parameter (see below)

has no effect, but the MOD AMOUNT (also below) sets the number of “jumps” that will

happen over the full range of the controller (MOD SRC).

Any of the 15 ASR-10 modulation sources can be used as the SRC (Modulation Source) for the

wave modulation.

EDIT

MOD AMT / RANGE

WAVE

Press Edit / Wave / 8 (Mod Amount) 9 (Mod Range)

1 2 ... 178 179 180 181 182 183 184 185 186 187 188 ... 389 390

Kommentare zu diesen Handbüchern

Keine Kommentare

ENSONIQ ASR-10 Bedienerhandbuch Seite 183

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Digitale Klaviere ENSONIQ ASR-10