ENSONIQ ASR-10 Bedienerhandbuch PDF herunterladen (Seite 285)

Section 13 — Sequencer and Audio Track Parameters

Edit/Seq•Song Parameters 3

EDIT

CLICK PAN - OUT (Output Routing)

SEQ•SONG

Press Edit / Seq•Song / 7

Use the Data Entry Slider or the Up/Down Arrow buttons to pan the click track within the stereo

field (-99 to +99). The OUT value will route the click to one of the three stereo effect busses

(BUS1, 2, or 3), or send it to one of the three pairs of outputs on the optional Output Expander

(AUX1, 2, or 3). The panning and output routing of the click is handled in the same manner as

WaveSample panning and output routing.

EDIT

SEQ COUNTOFF

SEQ•SONG

Press Edit / Seq•Song / 8

When:

• SEQ COUNTOFF=OFF — the song or sequence will start playing or recording as soon as you

press Play, or Record and Play (i.e. there is no count off).

• SEQ COUNTOFF=ON — you will hear one bar of click track before the sequencer goes into

Play or Record.

• SEQ COUNTOFF=RECORD — you will hear one bar of click track before the sequencer goes

into Record, but not prior to going into Play.

• SEQ COUNTOFF=QUIET — there is a silent one-bar count before the sequencer goes into Play

or Record.

EDIT

SEQ REC MODE

SEQ•SONG

Press Edit / Seq•Song / 9

The SEQ REC MODE parameter determines how sequence data will be recorded by the ASR-10

sequencer when you enter Record. Use the Data Entry Slider or the Up/Down Arrow buttons to

choose between the following options:

• SEQ REC MODE=REPLACE — Anything recorded into an existing track will replace data that

was in the track previously. The sequencer will stop recording after reaching the end of the

sequence or song, and will enter Audition/Play mode. When the SEQ REC SOURCE=

MULTI, REPLACE is automatically selected, and cannot be edited.

• SEQ REC MODE=ADD — New data recorded into an existing track will be added to (or

merged with) data already in the track. The existing data will be left intact. Again, the

sequencer will exit Record after reaching the end of the sequence or song, and will enter

Audition/Play.

• SEQ REC MODE=LOOPED — As with ADD mode, new data recorded into an existing track

will be added to (or merged with) data already in the track. However, when SEQ REC

MODE=LOOPED, the sequencer will remain in Record for as many times as you play through

the song or sequence (rather than dropping out of Record after reaching the end). Think of

this as “Drum Machine mode” — as long as the sequence or song keeps playing, you can keep

adding parts until you stop the sequencer.

1 2 ... 280 281 282 283 284 285 286 287 288 289 290 ... 389 390

Kommentare zu diesen Handbüchern

Keine Kommentare

ENSONIQ ASR-10 Bedienerhandbuch Seite 285

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Digitale Klaviere ENSONIQ ASR-10