ENSONIQ ASR-10 Bedienerhandbuch PDF herunterladen (Seite 104)

Section 6 — Effect Parameters ASR-10 Musician’s Manual

8 Edit/Effects Parameters

DIST GAIN IN and OUT Ranges: 0 to 99

These two parameters control the levels going into and coming out of the distortion effect. For

more distortion, use a high input level and turn the output level down to keep the volume under

control. For less distortion, use a low input level and a higher output level.

DIST LPF/HPF Range: 0 to 99

The DIST LPF parameter filters out high frequencies after the distortion signal path. The lower

the value, the less high frequencies pass through. The DIST HPF parameter filters out low

frequencies after the distortion signal path. The higher the value, the less low frequencies pass

through.

DIST FLANGE RATE Range: 0 to 99

This parameter controls the rate of modulation of the notches due to the flanger effect. A setting

of 0 effectively turns the flanger off.

SYSTEM FEEDBACK Range: -99 to +99

This parameter controls the amount of signal applied from the output of the reverb back into the

input of the compressor. The sign of the value determines the polarity of the feedback.

Note: Since the feedback level is taken from BUS1, if BUS1 is set to +0 or a low value, feedback will

have little or no consequence. Also, it is important to note that since the signal is being taken

from the reverb, that is also fed by BUS2, voices sent to BUS2 will enter the feedback loop along

with the BUS1 signals.

ROM-12 DIST+CHO+REV

A brighter guitar-and-amp simulator that features distortion, chorus, and reverb, but without the

compressor. The three effects can be run in a serial or parallel configuration, depending on how

the three BUS parameters are set. This effect uses the triple function effect mixing scheme.

BUS1 DIST INTO CHOR MIX Range: 0 to 99

This parameter determines how much of the output from the distortion bus will be fed into Bus2

for added chorusing. Setting this parameter to 0 will cause the output from the distortion bus to

go directly to the main outputs.

CHOR INTO REV MIX Range: 0 to 99

This parameter determines how much of the output from the chorus bus will be fed into Bus3 for

added reverb. Setting this parameter to 0 will cause the output from the chorus bus to go directly

to the main outputs.

BUS3 REVERB MIX Range: 0 to 99

Sets the Dry/Wet mix of the reverb.

DIST GAIN IN and OUT Ranges: 0 to 99

See the description under CMP+DIST+REV.

DIST FILTER FC Range: 0 to 99

This determines the filter cutoff frequency (brightness) of the distortion.

DIST FILTER Q Range: 1 to 25

This parameter determines the level of the resonant peak at the filter cutoff point. While the

FILTER FC parameter determines where (at what frequency) this peak will occur, the Q setting

controls the presence of the peak.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 389 390

Kommentare zu diesen Handbüchern

Keine Kommentare

ENSONIQ ASR-10 Bedienerhandbuch Seite 104

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Digitale Klaviere ENSONIQ ASR-10