ENSONIQ ASR-10 Bedienerhandbuch Seite 14

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 390
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 13
Section 1 — Controls and Architecture
Rear Panel Connections 3
8) Pedal•CV
This jack is for connecting an optional ENSONIQ Model CVP-1 Control Voltage Foot Pedal,
which is assignable as a modulator to various parameters within the ASR-10. The pedal gives
you a handy alternative modulation source when, for example, you would want to use the Mod
Wheel but both hands are busy.
ENSONIQ
CVP-1
Control Voltage Foot Pedal
A CV pedal plugged into this jack can also act as a Volume pedal, controlling the volume of the
currently selected Instrument•Sequence Track(s). A parameter on the Edit/System•MIDI page
(press Edit, then System•MIDI, then scroll until the display reads PEDAL=VOLUME MIDI=7),
determines whether the CV pedal will act as a modulator or as a volume pedal. Set to
PEDAL=VOLUME to use the CV pedal to control volume.
Pedal/CV Specs: 3-conductor (Tip= control voltage input, Ring=510 ohm resistor to +5 Volts,
Sleeve= ground). 36 KOhm input impedance, DC coupled. Input voltage range=0 to 3 volts DC.
Scan rate=32mS (maximum recommended modulation input= 15 Hz). For use with an external
control voltage, use a 2-conductor cable with the voltage on the tip and the sleeve grounded.
Seitenansicht 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 389 390

Kommentare zu diesen Handbüchern

Keine Kommentare