ENSONIQ ASR-10 Bedienerhandbuch PDF herunterladen (Seite 314)

Section 14 — Storage ASR-10 Musician’s Manual

4 Disk Functions

same size (both High-Density disks or both Double-Density disks). It is a good practice to

regularly back up your valuable data — including the O.S. disk which came with the ASR-10 —

in this way. You can use either blank or formatted disks. During the COPY FLOPPY DISK

command, the ASR-10 will ask you if you want to format the blank disk. Make sure the

formatted destination disks do not contain any files that you want to keep because they will be

erased. It is also a good idea to write-protect the source disk, so there’s no chance of losing data.

Note: This procedure uses the internal memory to temporarily hold the information while copying it

between disks. The fewer files you have loaded in the internal memory before you start, the

fewer times you will have to swap disks during the copy procedure. You will only have to swap

disks if the size of the source disk you are copying is greater than the amount of free internal

memory.

To Make a Backup Copy of a Disk:

• Slide open the plastic write-protect tab on the source disk (the original) so that the disk is

write-protected (you can see through the hole). This is an extra precaution to safeguard the

data.

• Press Command, then System•MIDI.

• Press the Right Arrow button repeatedly until the display shows COPY FLOPPY DISK.

• Press Enter•Yes. The display shows INSERT SOURCE DISK (the one you want to copy).

• Insert the source disk, then press Enter•Yes.

• The drive will engage and the display will flash READING SOURCE DISK. Once the drive

stops, the display will change to show INSERT DEST DISK.

• Insert the destination disk (the one you want to copy to), and then press Enter•Yes. If the

destination disk is unformatted, the display will ask ERASE AND FORMAT DISK? Press

Enter•Yes to format the disk. When formatting is complete, the drive will engage and the

display will flash WRITING DEST DISK.

• After writing to the destination disk, the display will read VERIFYING DEST DISK. If the

copy is complete, then the display will read DISK COMMAND COMPLETED.

• If the size of the source disk you are copying is greater than the amount of free internal

memory, the display will change to show INSERT SOURCE DISK again. Repeat the preceding

four steps as prompted by the ASR-10 display.

Note: When you copy a disk, the Disk Label Name is copied from the source disk to the destination

disk.

COPY FLOPPY messages:

• DISK WRITE-PROTECTED — When asked for the destination disk you inserted a write-

protected disk. The destination disk must have the write-protect tab closed (so you can’t see

through the hole).

• DISK IS NOT SOURCE DISK or DISK IS NOT DESTINATION DISK — You put the wrong

disk in the drive when prompted for a certain disk. This is not fatal; it doesn’t abort the copy

procedure. Just insert the requested disk and proceed.

1 2 ... 309 310 311 312 313 314 315 316 317 318 319 ... 389 390

Keine Kommentare

ENSONIQ ASR-10 Bedienerhandbuch Seite 314