ENSONIQ ASR-10 Bedienerhandbuch PDF herunterladen (Seite 237)

Section 12 — Sequencer and Audio Track Concepts ASR-10 Musician’s Manual

10 Recording a Sequence

To Copy an Instrument to Another Location:

Yes

Cancel Enter

1. Make sure the instrument you

want to make a copy of is selected.

Then,

2. While holding down an unused

Instrument•Sequence Track

button . . .

3. Press Enter•Yes

The display will read PIANO COPIED. Instrument•Sequence Track 4 now contains a copy of

the piano in Instrument•Sequence Track 1. You can now record on this track just as you would

any other. Keys, controllers, etc. recorded on the new track will be independent from any

recorded on Instrument•Sequence Track 1. You can Solo, Mute, MIX and PAN the new track

independently from the original. The new track can be assigned to its own MULTI-IN MIDI

CHANNEL and OUT bus. The two tracks simply “point to” the same sound. You can make as

many copies of an instrument as you want. Instrument copies will not take up much additional

memory, because they contain only “pointers” to the original sound.

Additional Notes

• When you select an Instrument•Sequence Track location that contains a copy, it looks just

like the original — the name and all its instrument parameters will be the same. In LOAD

mode you can adjust the volume of a copied instrument, select, deselect and stack it as you

would any instrument.

• These copied instruments are temporary things — the song or sequence doesn’t know that it’s

playing a copy (in fact the song or sequence never knows what instruments are loaded into

which locations). Any copied instruments will be forgotten when the ASR-10 is turned off

unless you save the contents of memory as a bank (using the SAVE BANK command on the

Command/Instrument page). When you load a bank, the ASR-10 recreates any copied

instruments that were there when the bank was saved.

• You cannot edit the instrument, layer, or wavesample parameters of the copy independently.

Any parameter changes made to the copy will affect the original, and vice-versa.

• If you load a new instrument into the Instrument•Sequence Track location that contains the

original instrument, any copies of that instrument will be automatically deleted from memory.

☞ Note: When using the Version 2 O.S., the processing of sequencer editing may take a little

longer than when using previous O.S. Versions. This is because the ASR-10 ensures the

accurate processing of information, and needs to prepare Audio Tracks with each edit.

1 2 ... 232 233 234 235 236 237 238 239 240 241 242 ... 389 390

Keine Kommentare

ENSONIQ ASR-10 Bedienerhandbuch Seite 237