ENSONIQ ASR-10 Bedienerhandbuch PDF herunterladen (Seite 362)

ASR-10 Musician’s Manual Section 18 — Audio Track Applications

An Audio Track Tutorial 5

4. If you do not hear audio when using a microphone, flip the Mic/Line Switch on the rear panel

of the ASR-10 up to the Mic position. You should now be able to hear the signal. However, it

may still be a bit too loud or soft.

Tip: You can overload the analog mic pre-amp by setting the Mic/Line switch to Mic for a line-level

signal source. This creates a fabulous analog distortion for guitar (or whatever) without using

the effects processor. Then use the effects processor to add chorus, reverb, or any other effect to

the analog distortion. This can then be sampled or recorded to Audio Tracks, or you can just play

along with sequences.

5. To further adjust the volume, turn the Input Level Trim Control knob on the rear panel of the

unit until the signal just begins to light the red Signal/Peak indicator.

The Input Level Trim Control knob increases the signal level when turned clockwise and

decreases the signal level when turned counter-clockwise (as viewed when facing the rear

panel).

6. Test your guitar or microphone.

Depending on the output level of your source, you may or may not hear signal coming

through the ASR-10. The left pair of Signal/Peak Input Level indicators will light when a

signal is present (green indicates a signal is detected, and red indicates the signal has reached

6 dB below the point of overload). You should see these indicators light when you hear audio.

Play Along with the Sequence

Now that you are set up for recording a RAMTrack, you may want to have a “practice run” to

play or sing along with the sequence before recording.

1. Make sure the Left Audio Track’s yellow and red LEDs are still lit. If not, press the Audio

Track A button until they are lit.

2. Press the Play button.

You will now hear the ATRK BLUES sequence, based on the classic 12-bar blues pattern, and

you can play/sing along with it for as long as you want.

3. Press Stop•Continue to stop the sequence.

Record Your First RAMTrack

When you are finished practicing, it’s time to record:

1. Make sure the Left Audio Track’s yellow and red LEDs are still lit. If not, press the Audio

Track A button until they light (if the yellow LED is not lit, you will not be recording an

Audio Track).

2. While holding down the Record button, press Play.

There will be a four bar countoff, followed by the sequence named “ATRK BLUES.”

3. Play your guitar along with the sequence, or “sing the blues” in your microphone. Here’s

some typical “blues lyrics”:

My baby done left me

I sure do got the blues

My dog died yesterday (substitute the animal of your choice; i.e. My

llama

died yesterday)

I sure do got the blues

I’m feeling so low

I sure do got the blues

1 2 ... 357 358 359 360 361 362 363 364 365 366 367 ... 389 390

Kommentare zu diesen Handbüchern

Keine Kommentare

ENSONIQ ASR-10 Bedienerhandbuch Seite 362

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Digitale Klaviere ENSONIQ ASR-10