ENSONIQ ASR-10 Bedienerhandbuch PDF herunterladen (Seite 27)

Section 1 — Controls and Architecture ASR-10 Musician’s Manual

16 About Memory

About the SIMM Socket

The SIMM socket uses the pins on the end of the latching posts to hold the SIMM in place. The

alignment notch on the SIMM prevents it from being installed backwards. Once installed, the

retaining posts hold the SIMM in place securely, preventing it from dropping out of the socket

inside the ASR-10.

ASR–10 SIMM Socket

Retaining Post

Latching Posts

To Remove a SIMM from a SIMM Socket:

Bend the two retaining posts out of the way…

just far enough to remove the SIMM

• Carefully spread open the retaining posts found on each end of the SIMM. Only spread the

posts as far apart as needed to clear the board; these posts can easily break if too much force is

applied. If broken, it will be very difficult to secure a new SIMM back into that socket. We

suggest spreading one post at a time; that way it’s easier to control the amount of pressure

being applied to remove the SIMM.

• Once the retaining posts are out of the way, tilt the SIMM toward you, and lift up and out of

the socket.

To Install a SIMM into a SIMM Socket:

Push

SIMM Installation - Side View

Press until SIMM

locks into position

Step 1

Step 2

• Place the connector edge of the SIMM into the SIMM Socket, pressing down slightly. The

latching holes on each end of the SIMM will line up with the latching posts when the SIMM is

seated properly.

• Tilt the SIMM back into the socket until the retaining posts snap in front of the SIMM. A

properly installed SIMM should look like this:

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 389 390

Keine Kommentare

ENSONIQ ASR-10 Bedienerhandbuch Seite 27