ENSONIQ ZR-76 Bedienungsanleitung PDF herunterladen (Seite 29)

Chapter 13ÑSupplemental Information

ENSONIQ ZR-76 MusicianÕs Manual 459

Use standard balanced (TRS) stereo cables or unbalanced (TS) mono cables for these connections.

As the labels on the Aux Out jacks and Main Out jacks indicate, the ZR employs automatic switching on

each stereo pair of outputs. That is:

¥ Main Outputs Right and Left are normally stereo outputs. However, if nothing is plugged into the Right

Output, the stereo signal will be summed to mono and sent to the Left Output.

¥ Similarly, the Aux Outputs Right and Left are normally stereo outputs. However, if nothing is plugged

into the Right Aux Output, the stereo signal will be summed to mono and sent to the Left Aux Output.

If there is nothing connected to the Left Aux Out jack, any signal sent to the Aux

Outputs will be summed into the Main Outputs.

The ZR-76 has Òground compensatedÓ outputs, which offer the advantages of balanced outputs (minimized

hum and interference), plus the advantage of a transformer isolated output (eliminates ground loop

problems). The output connector ÒgroundsÓ are not hooked directly to the ZR-76 ground, thus eliminating

the possibility of a ground loop. This ground compensating scheme works on both balanced and

unbalanced equipment with standard cables.

The ZR-76 ground compensating outputs make things very easy. Use of a standard 1/4Ó to XLR cable will

work fine with no ground loops.

1/4" to XLR Balanced Cable

3-Pin XLR male input

(balanced)

Black

Red

Shield

ENSONIQ 1/4" output

(ground compensated)

Case

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 43 44

Keine Kommentare

ENSONIQ ZR-76 Bedienungsanleitung Seite 29